: Turning these screws clockwise or counter-clockwise will raise or lower that side of the door to make it plumb.
Lift the (the one further inside the closet) first.
: Use a level or plumb line to ensure the side walls and floor are perfectly horizontal and vertical. instruktsiia po ustanovki dveri kupe
Installing sliding "coupe" doors (whether for a wardrobe or as an interior room divider) is a manageable DIY project that focuses on precise measurements and level tracks. 1. Preparatory Measurements Before installation, verify your opening dimensions.
: If your kit includes stoppers or soft-close mechanisms, slide them into the top track and tighten them at the points where the doors should stop. Recommended Tools Level and tape measure Drill with pilot bits Hacksaw (to trim tracks) Screwdriver (for adjustment screws) Installing a Sliding Closet Door Track : Turning these screws clockwise or counter-clockwise will
: If the door doesn't sit flush against the wall, locate the adjustment screws on the bottom rollers.
: Screw the roller brackets to the top (and sometimes bottom) of the door panels, usually 1–1.5 inches from the side edges. Mount the Panels : Installing sliding "coupe" doors (whether for a wardrobe
Angle the top into the rear groove of the upper track, then lower the bottom rollers into the rear groove of the bottom track. Repeat the process for the . 4. Final Adjustments