P1074464_wt.7z <2025-2027>

: This is the standard method where you select a "neutral plane" that determines the pull direction. The draft angle is then applied to the faces you select, pivoting them from that plane.

Based on community discussions regarding similar drafted features, here is how you can effectively apply a draft: p1074464_wt.7z

To draft a feature using the file (which likely contains a CAD model for a casting or molded part), you should apply a Draft feature to the relevant faces. This feature creates a taper that allows the part to be extracted from its mold easily. : This is the standard method where you

: For extremely difficult geometry, copy the surfaces, apply the draft to those surfaces, trim them, and then "Solidify" them back into the main part. copy the surfaces